Page 1 of 1
options ignored with groupproj
Posted: Thu Jan 21, 2021 10:54 am
by Richard_008
Whenever I use jtmake.exe to compile a .groupproj, my input options are ignored. So -FV2.1.8.5, -PV2.1.8.5, -treads5, but most importantly -c"Release Build" are all ignored. With a .cbproj, these options do work. What am I doing wrong?
Re: options ignored with groupproj
Posted: Thu Jan 21, 2021 5:50 pm
by jomitech
This is interesting. I'll investigate and get back to you.
Re: options ignored with groupproj
Posted: Tue Jan 26, 2021 7:33 pm
by jomitech
It looks like we are skipping these options when building project groups with jtmake. This issue will be resolved in the next release.
Re: options ignored with groupproj
Posted: Wed Jan 27, 2021 6:22 am
by Richard_008
Ahh, well, that explains a lot. Thanks for figguring it out! When (approximately) do you think this next release will be?
Re: options ignored with groupproj
Posted: Wed Jan 27, 2021 6:18 pm
by jomitech
Not 100% sure at this point when the release will go out. If it ends up taking longer than expected, we'll just provide an updated build of the current version.
Are you using TwineCompile downloaded via GetIt or off our site?
Re: options ignored with groupproj
Posted: Thu Jan 28, 2021 3:37 am
by Richard_008
I use TwineCompile via GetIt.
Re: options ignored with groupproj
Posted: Fri Jan 29, 2021 8:49 pm
by jomitech
We released the updated build last night. Can you re-download TwineCompile from GetIt and reinstall it?
Re: options ignored with groupproj
Posted: Sun Jan 31, 2021 10:17 am
by Richard_008
I installed the update (I am now on V5.2.2.292) and now everything works the way it should be. Thanks a lot!